Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE
Body Control System Connectors
WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For terminal identification of body control system connectors, see Fig 1
-21. Connector terminal numbers are molded into connectors. If connector terminal identification differs from what is shown in figure, use wire colors to ensure correct circuit is being tested. For wiring diagrams, see WIRING DIAGRAMSΒ
section at the end of this article.
CONNECTOR IDENTIFICATION
| Connector | See | |
|---|---|---|
| Body Control Module | ||
| Blue | Fig. Fig 1 | |
| Natural | Fig. Fig 2 | |
| CCD BUS Data Link | Fig. Fig 3 | |
| Compass/Mini-Trip Module | Fig. Fig 4 | |
| Front & Side Door Jamb Switch | Fig. Fig 5 | |
| Fuel Pump/Sending Unit | Fig. Fig 6 | |
| Instrument Cluster | Fig. Fig 7 | |
| Ignition Key In Ignition Switch | Fig. Fig 8 | |
| Left Pod Switch Assembly | Fig. Fig 9 | |
| Left Pod Switch Connectors | ||
| Black | Fig. Fig 10 | |
| Blue & Gray | Fig. Fig 11 | |
| Liftgate Switch | Fig. Fig 12 | |
| Multifunction Switch | Fig. Fig 13 | |
| Powertrain Control Module (PCM) | Fig. Fig 14 | |
| Radio Connectors | ||
| Black | Fig. Fig 15 | |
| Gray | Fig. Fig 16 | |
| Relay Block | Fig. Fig 17 | |
| Remote Keyless Entry (RKE) Module | Fig. Fig 18 | |
| Speaker Connectors | ||
| Door | Fig. Fig 19 | |
| Rear | Fig. Fig 20 | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
