1992 GMC Yukon AutomaticFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
ABS Module Mounted on side of brake master cylinder.
A/C Control/Front & Rear Heater Control Logic Module (Dual System) Above overhead console.
A/C & Heater Control Logic Module (Single System) In dash, behind instrument panel.
Audio Alarm Module On convenience center.
Check Engine Light Driver Module (6.2L) Under right side of dash, above blower motor.
Cruise Control Module On left side of firewall, near brake booster.
Daytime Running Lights (DRL) Module Behind left side of dash.
Diesel Elec. Control (DEC) Module (6.2L Diesel) Behind right side of dash. See Figure .
Electronic Control Module (ECM)
4.3L Behind right side of dash, above blower motor. See Figure .
5.0L & 5.7L Behind right side of dash, above blower motor. See Figure .
7.4L Behind right side of dash, above blower motor. See Figure .
5.7L (CNG) Behind right side of dash, above blower motor. See Figure .
Elec. Spark Control (ESC) Module
4.3L On right side of engine, on valve cover. See Figure .
5.0L & 5.7L On right side of engine, on valve cover. See Figure .
7.4L On right side of engine, on valve cover. See Figure .
Fuel Module
5.0L, 5.7L & 5.7L HD Behind right side of dash. See Figure .
7.4L Behind left side of dash, behind brake booster. See Figure .
Glow Plug Controller (6.2L) On left rear of intake manifold.
Hot Fuel Handling Module (5.7L & 7.4L) Behind right side of dash, above blower motor.
Low Coolant Module (6.2L) On center of firewall.
Powertrain Control Module (PCM) Behind right side of dash, above blower motor.
Transmission Control Module (TCM) Behind right side of dash.
Windshield Wiper Motor Module On firewall, behind wiper motor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.