1992 GMC Yukon AutomaticFACTORY OEM SERVICE PROCEDURE

Circuit Protection Devices

CIRCUIT PROTECTION DEVICES LOCATION

Component Location
Circuit Breakers On fuse block.
Battery Junction Block On right side of firewall.
Convenience Center Under left side of dash.
Fuel Pump In-Line Fuse (5.0L & 5.7L) On right side of firewall, near fuel pump relay. See Figure .
Fuse Supply Fuse (5.7L CNG) On right side of firewall. See Figure .
Fuse Block
4.3L Under left side of dash. See Figure .
5.0L & 5.7L Under left side of dash. See Figure .
7.4L Under left side of dash. See Figure .
5.7L (CNG) Under left side of dash. See Figure .
Fusible Links At battery junction block.
Power Mirrors In-Line Fuse Taped to harness, above fuse panel.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.