1992 GMC Yukon AutomaticFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
Convenience Center Under Left Side of Instrument Panel. See Fig 1 .
Fuse Block Lower Left Side of Instrument Panel. See Fig 2 .
Master Window Switch On Left Front Door Trim Panel. See Fig 3 .
Window Motor Behind Respective Door Trim Panel. See Fig 3 .
Window Switch On Respective Door Trim Panel. See Fig 3 .
C240 (Crew Cab, Utility & Suburban) At Convenience Center. See Fig 4 .
C244 (Crew Cab, Utility & Suburban) At Radio.
C247 (2-Door, Extended Cab & Suburban) At Convenience Center. See Fig 4 .
C257 At Convenience Center. See Fig 4 .
C325 (2-Door, Extended Cab & Suburban) Left Body Hinge Pillar. See Fig 4 .
C326 (Crew Cab, Utility & Suburban) Left Body Hinge Pillar. See Fig 4 .
C328 (Crew Cab, Utility & Suburban) Right Body Hinge Pillar. See Fig 4 .
C330 (Crew Cab, Utility & Suburban) Right Body Hinge Pillar. See Fig 4 .
C331 (2-Door & Extended Cab) Right Body Hinge Pillar. See Fig 4 .
C332 (Crew Cab, Utility & Suburban) Left Body Hinge Pillar. See Fig 4 .
C341 (Crew Cab, Utility & Suburban) At Left Center Pillar. See Fig 5 .
C342 (Crew Cab, Utility & Suburban) At Right Center Pillar. See Fig 5 .
G202 At ALDL Connector. See Fig 6 .
S207 Under Left Side Of Instrument Panel. See Fig 2 .
S213 (Crew Cab, Utility & Suburban) Under Left Side Of Instrument Panel. See Fig 2 .
S272 (Crew Cab, Utility & Suburban) In Power Window & Door Locks Harness, Near Convenience Center Leads. See Fig 4 .
S277 (Crew Cab, Utility & Suburban) In Power Window & Door Locks Harness, Near Convenience Center Leads. See Fig 4 .
S279 In Power Window & Door Locks Harness, Near Convenience Center Leads. See Fig 4 .
S500 (Crew Cab, Utility & Suburban) In Power Window & Locks Harness, Left Front Door, Near Power Window Motor Lead. See Fig 3 .
S501 In Power Window & Locks Harness, Left Front Door, Near Power Window Motor Lead. See Fig 3 .
Fig 1: Locating Convenience Center
G00149409Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.