1992 GMC Magnavan 7.4 NFACTORY OEM SERVICE PROCEDURE

Force Motor Circuit Check: Notes

NOTE: This flow chart requires the use of a bidirectional (Tech 1) scan tester.

The force motor is a PCM/TCM-controlled device used to regulate transmission line pressure. The PCM/TCM looks at TPS voltage, engine RPM, and other inputs to determine the appropriate line pressure for a given load, then regulates the pressure by applying a variable amperage to the force motor. The applied amperage varies from .1-1.1 amps.

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Checks the PCM and TCM's ability to command the force motor.
  2. Checks for voltage at PCM/TCM.
  3. Checks internal transmission harness and force motor for low resistance.
  4. Checks for short to ground.
  5. Checks internal transmission harness and force motor for high resistance.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.