1992 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE

Speed (Cruise) Control Switch

WARNING: This page is about a different car, the 1995 Dodge Pickup and 1995 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect speed control switch 4-pin connector. Using an ohmmeter, check for continuity at speed control switch. See Fig 1 . If continuity is not as specified in SPEED CONTROL SWITCH CONTINUITYΒ  table, replace defective speed control switch.

SPEED CONTROL SWITCH CONTINUITY

Switch Position Check Between Terminals No. Continuity
OFF 1 & 4 Yes
ON 1 & 4 Yes
ON 1 & 2 Yes
ON 2 & 4 Yes
ON & SET 1 & 2 Yes
ON & RESUME 1 & 3 Yes
Fig 1: Testing Speed (Cruise) Control Switch Continuity
G94A65839Courtesy of CHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.