1992 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE

Speed Control Switch

WARNING: This page is about a different car, the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Dodge Grand Caravan, 1995 Dodge Caravan, and 1995 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.

Access speed control switch. Disconnect speed control switch connector. See Figure . Using an ohmmeter, check speed control switch. If speed control switch does not test as specified in SPEED CONTROL SWITCH table, replace switch.

SPEED CONTROL SWITCH

Switch Position Check Between Terminals No. Ohms
OFF 3 & 4 5890-6510
OFF 1 & 3 (1)
ON 1 & 4 5890-6510
ON 1 & 3 (2)
ON/SET 3 & 4 1020-1130
ON/RESUME 3 & 4 2040-2260
(1) No continuity should exist.
(2) Continuity should exist.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.