1992 GMC Forward Control 7.4 NFACTORY OEM SERVICE PROCEDURE

Diagnostic Aids

If the engine is allowed to cool overnight, the coolant temperature sensor and MAT sensor should read close to each other, when measured with a Scan tester. A Code 25 will also result if sensor signal circuit is shorted to ground.

CODE 25 ECM TERMINAL & CIRCUIT WIRING ID (2.5L)

Application ECM Terminal Wire Color
Signal C12 Tan
MAT Ground D2 Black/Red
CODE 25 ECM TERMINAL & CIRCUIT WIRING ID (4.3L TURBO)

Application ECM Terminal Wire Color
Signal GF16 Tan
MAT Ground BB5 Black
TEMPERATURE-TO-RESISTANCE VALUES(1)(2)

Β°F (Β°C) Ohms
210 (100) 185
160 (70) 450
100 (38) 1800
70 (20) 3400
40 (4) 7500
20 (-7) 13,500
0 (-18) 25,000
-40 (-40) 100,700
(1) Measure resistance across sensor terminals.
(2) Temperatures are approximates.
Fig 1: Code 25 Schematic (2.5L & 4.3L Turbo) MAT Sensor Temperature High
G91E07386
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.