Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 GMC Jimmy 5.7 K, StandardFACTORY OEM SERVICE PROCEDURE
External Pages
These are pages that do not belong to the exact selected vehicle (1990 GMC Jimmy 5.7 K, Standard), but are still accessible from a link in your vehicle's manual. Be very cautious using repair info from here because these pages may not apply to your vehicle.
- Different variant/trim
- Different car
- Section 1 (Computer Relearn Procedures)
- Section 2 (Computer Relearn Procedures)
- Section 3 (Wiper/Washer Systems - C/K Series Pickups)
- Section 4 (Disc Brake System & Drum Brake System)
- Section 5 (SUSPENSION - FRONT ( R Series 2WD))
- Section 6 (SUSPENSION - FRONT ( C Series 2WD))
- Section 7 (Suspension - Front (2WD Coil Spring))
- Section 8 (Suspension - Front (4WD) - Torsion Bar)
- Section 9 (BENDIX - Hydraulic Brake Booster)
- Section 10 (Drive Axle - Front)
- Section 11 (Drive Axle - 7.5", 7.625", 8.5" & 9.5")
- Section 12 (Removal & Installation - M/T)
- Section 13 (Suspension - Front (AWD & 4WD))
- Section 14 (Diagnosis - A/T)
- Section 15 (Servicing - M/T)
- Section 16 (Servicing - M/T)
- Section 17 (Servicing - M/T)
- Section 18 (Servicing - M/T)
- Section 19 (Servicing - M/T)
- Section 20 (Servicing - M/T)
- Section 21 (Servicing - M/T)
- Section 22 (Servicing - M/T)
- Section 23 (Servicing - M/T)
- Section 24 (Removal & Installation - M/T)
- Section 25 (Removal & Installation - M/T)
- Section 26 (Removal & Installation - M/T)
- Section 27 (Removal & Installation - M/T)
- Section 28 (Removal & Installation - M/T)
- Section 29 (Removal & Installation - M/T)
- Section 30 (Removal & Installation - M/T)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
