Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition System - HEI (CARBURETED Models): Description
The Delco-Remy High Energy Ignition (HEI) system consists of ignition coil, spark plugs, distributor assembly and primary and secondary wiring.
The distributor housing contains an electronic control module, pick-up coil, pole piece, timer core, rotor, capacitor for radio noise suppression and timing advance mechanisms. Most applications house the ignition coil assembly within the distributor cap. See Fig 1. Full battery voltage is present at the battery terminal of distributor cap in either "START" or "RUN" position. Ballast resistance is not used in the primary system.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
