1987 GMC Forward Control 5.7 M, StandardFACTORY OEM SERVICE PROCEDURE

Engine Compression

When making compression checks, disconnect ignition switch Pink wire from High Energy Ignition (HEI) system. Remove air cleaner. Set throttle and choke in wide open position. Remove all spark plugs and crank engine through at least 4 compression strokes.

COMPRESSION SPECIFICATIONS

Application Specification
Compression Ratio 8.0:1
Compression Pressure 130 psi (9.1 kg/cm2 )
Maximum Pressure Variation 30 psi (2.1 kg/cm2 )
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.