1987 GMC Forward Control 4.8 T, StandardFACTORY OEM SERVICE PROCEDURE

Ignition System - HEI (CARBURETED Models): Description

The Delco-Remy High Energy Ignition (HEI) system consists of ignition coil, spark plugs, distributor assembly and primary and secondary wiring.

The distributor housing contains an electronic control module, pick-up coil, pole piece, timer core, rotor, capacitor for radio noise suppression and timing advance mechanisms. Most applications house the ignition coil assembly within the distributor cap. See Fig 1. Full battery voltage is present at the battery terminal of distributor cap in either "START" or "RUN" position. Ballast resistance is not used in the primary system.

Fig 1: Exploded View of HEI Distributor
G9006Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.