1985 GMC Jimmy 6.2 CFACTORY OEM SERVICE PROCEDURE

Miscellaneous Components

MISCELLANEOUS COMPONENTS LOCATION

Component Location
A/C-Heater Blower Resistor On evaporator case in engine compartment. See Figure.
Assembly Line Data Link (Calif.) Under right side of dash.
"CHECK ENGINE" Light Driver (Calif.) On wiring harness above ECM. See Figure.
Convenience Center Under left side of dash.
Diag. Dwell Meter Connector (Calif.) In wiring harness below differential pressure sensor. See Figure.
Fuel Filter/Heater/Water Detector (6.2L) On firewall in engine compartment.
Fuse Block Under left side of dash.
Power Window Circuit Breaker On fuse block.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.