1985 GMC Forward Control 7.4 W, StandardFACTORY OEM SERVICE PROCEDURE

Clearing Trouble Codes

Trouble codes should be cleared when indicated in Diagnostic Circuit Check chart, and after the repair of a circuit. To clear trouble codes, the fused 12-volt source to ECM must be disconnected for 10 seconds by disconnecting the positive battery terminal or removing the "ECM B" fuse at the fuse panel.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.