1985 GMC Forward Control 5.7 M, StandardFACTORY OEM SERVICE PROCEDURE

Testing Precautions

The following precautions MUST be observed during testing procedures:

  • DO NOT  ground tachometer terminal of distributor connector. Damage to the electronic module or ignition coil can result.
  • Disconnect ignition switch connector at distributor before making compression checks.
  • When using a timing light, connect at plug end of number 1 spark plug wire. DO NOT  pierce plug boot.
  • Remove spark plug wires, twist boot 1/2 turn and pull on boot (not on wire).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.