1982 GMC Magnavan Standard TransFACTORY OEM SERVICE PROCEDURE

Bleeding Sequence

Before bleeding system, exhaust all vacuum from power unit by depressing brake pedal several times. Bleed master cylinder if equipped with bleeder screws, then bleed slave cylinder on vehicles equipped with remote power assist units. Bleed wheel cylinders and calipers in correct sequence.

BLEEDING SEQUENCE

Jeep RR, LR, RF, LF, Master Cyl. Lines
All Other Models RR, LR, RF, LF
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.