Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 GMC Magnavan Standard TransFACTORY OEM SERVICE PROCEDURE
Intermittent System Problems
- Using a spark tester or modified spark plug, check for spark at 2 spark plug wires. If no spark results, see SYSTEM TESTING . If spark is noted on one or both wires, check for dwell increase from low to high RPM.
- Check pick-up coil with ohmmeter leads attached to Green and White wires, removed from HEI module. If reading does not indicate between 500-1500 ohms, replace pick-up coil. If pick-up coil reading was satisfactory, and dwell did not increase, replace electronic module.
- If pick-up coil was satisfactory, but dwell increased, check fuel, spark plug wires, distributor cap, rotor or spark plugs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.