Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Freightliner Sprinter 2500 V6-3.0L DSL TurboFACTORY OEM SERVICE PROCEDURE
System Specifications
Timing Chain Tensioner
Install the timing chain tensioner retaining bolt.
Tighten to 12 Nm (106 lbs. in.)
Crankshaft Damper
Align the alignment key in the crankshaft with the key way in the damper and install the vibration damper. Tighten the bolt to 304 Nm, plus 90 degrees (224 ft. lbs. plus 90 degrees).
Install the timing cover
Tighten bolts to 9 Nm (7 ft. lbs.).
Install the timing chain tensioner retaining bolt.
Tighten to 12 Nm (106 lbs. in.)
Crankshaft Damper
Align the alignment key in the crankshaft with the key way in the damper and install the vibration damper. Tighten the bolt to 304 Nm, plus 90 degrees (224 ft. lbs. plus 90 degrees).
Install the timing cover
Tighten bolts to 9 Nm (7 ft. lbs.).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.