Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Freightliner Sprinter 2500 V6-3.0L DSL TurboFACTORY OEM SERVICE PROCEDURE
Data Link Connector: Locations
DESCRIPTION
The Data Link Connector (DLC) (1) is a 16-way molded plastic connector insulator with a hinged molded plastic cover. This connector is located on the left cowl side inner trim cover below the driver side outboard end of the instrument panel (2), inboard of the inside hood release lever (4).
The DLC connector insulator is retained to the upper edge of the fuse and relay box (3) opening of the cowl side inner trim cover by two screws and is concealed beneath the removable access panel for the fuse and relay box.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.