Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Freightliner Sprinter 2500 V6-3.0L DSL TurboFACTORY OEM SERVICE PROCEDURE
Rear Blower Motor Power Module - Removal
REMOVAL
WARNING: The heat sink for the rear blower motor power module may get very hot during normal operation. If the rear blower motor was turned on prior to servicing the rear power module, wait five minutes to allow the heat sink to cool before performing diagnosis or service. Failure to take this precaution can result in possible personal injury.
1. Disconnect and isolate the negative battery cable.
2. Remove the air outlets (1).
3. Remove the dome lamps (3).
4. Remove the screws (4 and 7) that secure the front, center and rear roof duct trim panels (2, 9 and 8) to the roof duct.
5. Remove the front roof duct trim panel by sliding it forward.
6. Remove the rear and center roof duct trim panels by sliding them rearward.
7. Disengage the retaining tabs that secure the air intake grille (5) into the rear evaporator trim panel (10) and remove the grille.
8. Remove the screws (6) that secure the rear evaporator trim panel to the roof duct.
9. Remove the rear evaporator trim panel by sliding it to the right of the vehicle.
10. Rotate the rear blower motor power module (3) counterclockwise 1/4 turn and remove it from the rear evaporator housing (1)
11. Disconnect the wire harness connector (2) from the rear blower motor power module and remove the module.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
