Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Freightliner Sprinter 2500 V6-3.0L DSL TurboFACTORY OEM SERVICE PROCEDURE
Manual Temperature Control (MTC)
MANUAL TEMPERATURE CONTROL (MTC)
1. Position the A/C-heater control (1) to the instrument panel.
2. Connect the wire harness connectors (5) to the back of the A/C-heater control (1) and engage the connector lock (4). Make sure the connector lock is fully engaged.
3. Connect the blend door cable (3) to the rear of the A/C heater control and engage the cable retaining tab (2). If necessary, rotate the cable slightly to align the spline on the cable with the receptacle in the control. Make sure the retaining tab is fully engaged to the control.
NOTE: ATC A/C-heater control shown. MTC control similar.
4. Install the A/C-heater control (2) into the instrument panel (3) while simultaneously connecting the mode control cable to the mode door cam located at the rear of the HVAC housing. If necessary, rotate the cable slightly to align the spline on the cable with the receptacle in the cam.
5. Install the four screws (1) that secure the A/C-heater control to the instrument panel. Tighten the screws to 2 Nm (17 in. lbs.).
6. Install the instrument panel center bezel.
7. Reconnect the negative battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
