Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Freightliner Sprinter 2500 V6-3.0L DSL TurboFACTORY OEM SERVICE PROCEDURE
Automatic Temperature Control (ATC)
AUTOMATIC TEMPERATURE CONTROL (ATC)
1. Position the A/C-heater control (1) to the instrument panel.
2. Connect the wire harness connectors (4) to the back of the A/C-heater control and engage the connector locks (2). Make sure the connector locks are fully engaged.
3. Install the A/C-heater control (2) into the instrument panel (3).
4. Install the four screws (1) that secure the A/C-heater control to the instrument panel. Tighten the screws to 2 Nm (17 in. lbs.).
5. Install the instrument panel center bezel.
6. Reconnect the negative battery cable.
7. If replacing the A/C-heater control, initiate the Actuator Calibration function using a scan tool.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.