Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Freightliner Sprinter 2500 V6-3.0L DSL TurboFACTORY OEM SERVICE PROCEDURE
Module-Auxiliary Heater 1
Component ID: 258
Component : MODULE-AUXILIARY HEATER 1
Connector:
Name : MODULE-AUXILIARY HEATER 1 C1
Color : BLACK
# of pins : 8
Pin Description Circuit
1 TERM.30 2773 12RD/VT
2 GROUND 2772 12BR
3 BLOWER CONTROL SIGNAL-PARKING HEATER -
4 DOSING PUMP-PLUS SUPPLY 2771 16DG/RD
5 CAN B BUS (+) 34 20BR/RD
6 CAN B BUS (-) 35 20BR
7 PLUS ADDITIONAL WATER PUMP -
8 - -
Connector:
Name : MODULE-AUXILIARY HEATER 1 C2
Color :
# of pins : 4
Pin Description Circuit
1 - -
2 SWITCH-LED YELLOW 3838 20OR
3 RADIO FREQUENCY REMOTE CONTROL ON 3838 20OR
4 - -
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
