2006 Freightliner Sprinter 2500 L5-2.7L DSL TurboFACTORY OEM SERVICE PROCEDURE

Maintenance Service

SCOPE OF WORK FOR MAINTENANCE SERVICE

Oil Service
- Engine: Oil change and filter replacement

Check fluid levels of the following system, refill as necessary.
- If fluid is lost, trace and eliminate cause - as a separate order.
- Power-assisted steering

Lubrication work:
- Trailer tow hitch (original equipment)

Maintenance
- ASSYST maintenance computer reset

Function check
- Signalling system, warning and indicator lamps
- Headlamps, exterior lighting
- Windscreen wipers, windscreen washer system

Check for leaks and damage.
- Check for abrasion points and ensure that lines are correctly routed!
- All lines and hoses, sensor cables
- Rubber boots on front axle drive shafts, rubber boots on front axle suspension ball joints, shock absorbers

Check fluid levels for the following systems, correct as necessary.

Note: Should there be a loss of fluid which cannot be explained by regular use, trace and eliminate the cause.

- Engine cooling system. Check corrosion inhibitor/antifreeze, refill as necessary.
- Hydraulic brake system
- Battery
- Windscreen washer system

Engine
- Fuel filter renewal
- Air cleaner with maintenance indicator
- Check degree of contamination.
- Air cleaner filter element renewed as necessary.

Chassis and body
- Trailer coupling: Check operation, play and retaining fixtures
- Secondary rubber springs: Visual check
- Tire pressures: Correct as necessary, including spare tire
- Check thickness of brake pads
- Brake test
- Check condition of steering mechanism
- Heating/ventilation dust filter renewal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.