2005 Freightliner Sprinter 2500 L5-2.7L DSL TurboFACTORY OEM SERVICE PROCEDURE

Additional Maintenance Work




ADDITIONAL MAINTENANCE WORK

Automatic transmission once only at 80,000 miles / 128,000
km

- Oil and filter change

CAUTION: Use of the approved fluid is required if the ASSYST Oil Service Reminder is followed. Use of a lower quality oil on this service schedule may cause severe engine damage. Fluid Type Specifications

During every second maintenance service
- Air cleaner without maintenance indicator:
- Air cleaner filter element renewal
- Check poly-V-belt for wear and signs of damage

During every sixth maintenance service
- Change rear axle fluid

Every 2 years
- Change brake fluid

Every 3 years
- Air cleaner filter element renewal (note installation date)

Every 15 years or 100,000 miles
- Coolant renewal (Note coolant composition)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.