2005 Freightliner Sprinter 2500 L5-2.7L DSL TurboFACTORY OEM SERVICE PROCEDURE

Rear A/C Heater Control

REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the air filter from the rear A/C evaporator housing.

Rear A/C Control Module:

Factory service manual diagram



3. Reach up into the rear A/C evaporator housing and disconnect the wire harness connector from the rear A/C control module.
4. Remove the two screws that secure the rear A/C control module to the rear A/C evaporator housing and remove the control module.

INSTALLATION
1. Position the rear A/C control module to the rear A/C evaporator housing.
2. Install the two screws that secure the rear A/C control module to the rear A/C evaporator housing. Tighten the screws to 2 N.m (17 in. lbs.).
3. Connect the wire harness connector to the rear A/C control module.
4. Install the rear air filter.
5. Reconnect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.