2003 Freightliner Sprinter 3500 L5-2.7L DSL TurboFACTORY OEM SERVICE PROCEDURE

Procedures

REMOVAL
1. Disconnect the negative battery cable.
2. Detach the air hose at the Manifold Air Flow (MAF) sensor
3. Unplug the MAF wiring harness connector.
4. Remove the screws retaining the MAF sensor to the air cleaner housing, and remove MAF sensor.

INSTALLATION

Manifold Air Flow Sensor:

Factory service manual diagram



1. Position the MAF sensor to air cleaner housing and install the retaining screws.
2. Connect the air intake hose to the MAF sensor and tighten clamp.
3. connect the MAF wiring harness connector.
4. Connect negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.