2003 Freightliner Sprinter 2500 L5-2.7L DSL TurboFACTORY OEM SERVICE PROCEDURE

Ignition Switch: Service and Repair

KEY/LOCK CYLINDER

REMOVAL
1. Remove the securing cover for the central electronics.
2. Remove the steering column shroud.

Factory service manual diagram




3. Remove the transponder coil off the ignition lock (Fig. 3).
4. Insert the key into the ignition lock.

Factory service manual diagram




5. Turn the ignition key to the first detent (Fig. 4).

Factory service manual diagram




6. Turn the cap a οΏ½ turn to the left (Fig. 5).

Factory service manual diagram




7. Remove cap together with the lock cylinder off the ignition lock (Fig. 6).

INSTALLATION
1. Install the cap together with the lock cylinder onto the ignition lock (Fig. 6).
2. Turn the cap a οΏ½ turn to the right.
3. Turn the ignition key to the first detent (Fig. 4).
4. Remove the ignition key from the ignition lock.
5. Install the transponder coil onto the ignition lock (Fig. 3).
6. Install the steering column shroud. Pay attention to the cables routed under the steering column cover. Do not trap the cables.
7. Install the cover for the central electronics.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.