Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Freightliner Sprinter 3500 L5-2.7L DSL TurboFACTORY OEM SERVICE PROCEDURE
Computer/Controls - Programming Control Units
Date: May 6, 2010
Order No.: V-B-54.21/09
Group: 54
SUBJECT:
MY-All, Model 903, 904, and 906
Programming Control Units
Before programming control units, make sure that the latest software release is on the diagnostic system! The available add-ons must always be installed before starting any control unit programming!
Order No.: V-B-54.21/09
Group: 54
SUBJECT:
MY-All, Model 903, 904, and 906
Programming Control Units
Before programming control units, make sure that the latest software release is on the diagnostic system! The available add-ons must always be installed before starting any control unit programming!
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.