2002 Freightliner Sprinter 2500 L5-2.7L DSL TurboFACTORY OEM SERVICE PROCEDURE

Fuse Block: Service and Repair

Fuse Block 1

REMOVAL
1 Disconnect and isolate the negative battery cable.
2. Remove fuse block cover by rotating locking screw 90 °.
3. Remove the steering column cover. Refer to the Body section for the procedure.
4. Unscrew fuse block connections and disconnect all electrical connectors from the fuse block.
5. Remove the fuse block from the steering column.

INSTALLATION
1. Position the fuse block in the steering column.
2. Install fuse block connections and connect all electrical connectors on the fuse block.
3. Install the steering column cover. Refer to the Body section for the procedure.
4. Install fuse block cover by rotating locking screw 90 °.
5. Connect the negative battery cable.
6. Set time and radio stations.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.