2024 Ford Explorer TimberlineFACTORY OEM SERVICE PROCEDURE

Pinpoint Test Av: Abs (Anti-Lock Brake System) Module Communication Concern With GSM (Gear Shift Module)

Refer to: MODULE COMMUNICATIONS NETWORK for schematic and connector information.

Normal Operation and Fault Conditions 

With the ignition ON, the GSM sends messages to the ABS module over the HS-CAN2. If the ABS module does not receive these messages within the specified time frame, the ABS module sets Diagnostic Trouble Codes (DTCs). This can be due to a GSM failure, a circuit failure on the CAN or an excessive load on the network. For information on the messages sent to the ABS module by the GSM, REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description  .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Condition
ABS U0103:00 Lost Communication With Gear Shift Control Module A: No Sub Type Information Sets if the GSM messages are missing.
ABS U0404:86 Invalid Data Received from Gear Shift Control Module A: Signal Invalid Sets if the GSM state message or the GSM button quality state is invalid or faulty.

Possible Sources 

  • Network communication concern
  • GSM

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.