2024 Ford Expedition TimberlineFACTORY OEM SERVICE PROCEDURE

Disassembly And Assembly Of Subassemblies: Piston: Assembly

  1. If the piston and/or connecting rod are being installed new, the piston rod orientation marks and the arrow on the top of the dome of the piston should be facing toward the front of the engine block.
    GFD859588Courtesy of FORD MOTOR COMPANY
  2. Install the piston to the connecting rod.
    GFD859589Courtesy of FORD MOTOR COMPANY
  3. Lubricate with clean engine oil and install the piston pin. Refer to: SpecificationsΒ .
    GFD859590Courtesy of FORD MOTOR COMPANY
  4. NOTE: The piston pin retaining clip gap orientation must be toward the top or dome of piston.

    Install the piston pin retainers.

    GFD859591Courtesy of FORD MOTOR COMPANY
  5. Inspect the lower compression ring to identify the orientation. The top of the lower compression ring will be angled at the top and notched on the bottom.

    1. Top Side.

    GFD859592Courtesy of FORD MOTOR COMPANY
  6. Lubricate with clean engine oil and install the piston rings. Refer to: SpecificationsΒ .
    GFD859593Courtesy of FORD MOTOR COMPANY
  7. NOTE: The piston compression upper ring should be installed with the "O" mark on the ring face pointing up toward the top of the piston.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.