Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test BV: Abs (Anti-Lock Brake System) Module Communication Concern With SCCM (Steering Column Control Module)
REFER to: MODULE COMMUNICATIONS NETWORK for schematic and connector information.
Normal Operation and Fault Conditions
With the ignition ON, the SCCM sends messages to the ABS module over the HS-CAN2. If the ABS module does not receive these messages within the specified time frame, the ABS module sets Diagnostic Trouble Codes (DTCs). This can be due to a SCCM failure, a circuit failure on the CAN or an excessive load on the network. For information on the messages sent to the ABS module by the SCCM, REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS U0212:86 | Lost Communication With Steering Column Control Module: Signal Invalid | If the ABS module receives the front wiper status messages from the SCCM with an invalid value for more than the allowed time, this DTC is set. |
| ABS U0212:87 | Lost Communication With Steering Column Control Module: Missing Message | If the ABS module does not receive the steering angle messages from the SCCM within a pre-determined time frame, this DTC is set. |
Possible Sources
- Network communication concern
- SCCM
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
