2023 Ford Expedition TimberlineFACTORY OEM SERVICE PROCEDURE

Pinpoint Test CE: Abs Module Communication Concern With HVAC Module

Normal Operation and Fault Conditions 

With the ignition ON, the HVAC control module sends messages to the GWM over the MS-CAN, The GWM relays these messages to the ABS module over the FD-CAN. If the ABS module does not receive these messages within the allotted time frame or if the messages contain invalid data, the module sets a DTC. This can be due to a HVAC control module failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the HVAC control module, REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Condition
ABS U0164:00 Lost Communication With HVAC Control Module: No Sub Type Information This DTC sets when the ABS module does not receive any messages from the HVAC module within the allowed time.
ABS U0424:86 Invalid Data Received From HVAC Control Module: Signal Invalid This DTC sets when the ABS module receives messages from the HVAC module, but the messages contain invalid data.

Possible Sources 

  • Network communication concern
  • GWM
  • HVAC control module

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.