WARNING: This page is about a different car, the 2022 Ford Bronco Sport. However, it is still accessible from the selected car via links, so may be relevant.

The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Programmable Parameters
ABS module	760	Yes	Yes	IVD initialization	None
ACM	727	Yes	Yes	No	None
APIM	7D0	Yes	Yes	No	None
ATCM	792	No	No	No	None
AWD module	703	Yes	Yes	No	None
BCM	726	Yes	Yes	No	Battery type configuration
BECMB	723	Yes	Yes	No	None
CCM	764	Yes	Yes	No	None
DDM	740	Yes	Yes	Windows initialization	None
DSP	783	Yes	Yes	No	None
GSM	732	Yes	Yes	No	None
GWM	716	Yes	Yes	No	None
HVAC module	733	Yes	Yes	No	None
IPC	720	Yes	Yes	No	None
IPMA	706	Yes	Yes	Camera calibration	None
IPMB	7B1	Yes	Yes	Camera calibration	None
OCS module	765	No	No	OCS module re-zero	None
PAM	736	Yes	Yes	No	None
PCM	7E0	Yes	Yes	No	None
PDM	741	Yes	Yes	Windows initialization	None
PSCM	730	Yes	Yes	Drive the vehicle for at least 3 minutes, with straight driving above 50 km/h (30 mph) for at least 30 seconds.	None
RCM	737	Yes	Yes	No	None
RTM	751	Yes	Yes	No	None
SCCM	724	Yes	Yes	No	None
SODL	7C4	Yes	Yes	No	Blockage enable
SODR	7C6	Yes	Yes	No	Blockage enable
TCU	754	Yes	Yes	No	None
TRM	791	Yes	Yes	No	None
WACM	725	Yes	Yes	No	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?