2023 Ford Escape ST-Line SelectFACTORY OEM SERVICE PROCEDURE

Pinpoint Test Bx: Abs Module Communication Concern With The All-Wheel Drive (AWD) Control Module

WARNING: This page is about a different car, the 2023 Ford Bronco Sport. However, it is still accessible from the selected car via links, so may be relevant.

Normal Operation and Fault Conditions 

With the ignition ON, the AWD control module sends messages to the GWM over the HS-CAN1. The GWM relays the messages to the ABS module over the HS-CAN2. If the ABS module does not receive these messages within the allotted time frame or if the messages contain invalid data, the module sets a DTC. This can be due to a AWD control module failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the AWD control module, refer to the Network Message Chart in NETWORK MESSAGE CHART .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Condition
ABS U011D:00 Lost Communication With All Wheel Drive Control Module: No Sub Type Information This DTC sets when the ABS module does not receive any messages from the AWD control module within the allowed time.
ABS U041E:00 Invalid Data Received From All Wheel Drive Control Module: No Sub Type Information This DTC sets when the ABS module receives messages from the AWD control module, but the messages contain invalid data.

Possible Sources 

  • Network communication concern
  • AWD control module

Pinpoint Tests BX: ABS Module Communication Concern With The AWD Module

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.