Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test Z: Abs (Anti-Lock Brake System) Module Configuration Concern
Refer to VEHICLE DYNAMIC SYSTEMS for schematic and connector information.
Normal Operation and Fault Conditions
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets.
REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS U2017:57 | Control Module Software #2: Invalid/Incompatible Software Component | Sets due to incomplete or improper module programming procedures. |
| ABS U2017:93 | Control Module Software #2: No Operation | Sets due to incomplete or improper module programming procedures. |
| ABS U2018:57 | Control Module Software #3: Invalid/Incompatible Software Component | Sets due to incomplete or improper module programming procedures. |
| ABS U2100:00 | Initial Configuration Not Complete: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS C1018:61 | Regenerative Braking: Signal Calculation Failure | Sets due to incomplete or improper module programming procedures. |
| ABS C101F:46 | Generic Valve Failure: Calibration/Parameter Memory Failure | Sets due to incomplete or improper module programming procedures. |
| ABS C101F:49 | Generic Valve Failure: Internal Electronic Failure | Sets due to incomplete or improper module programming procedures. |
| ABS U0300:51 | Internal Control Module Software Incompatibility: Not Programmed | Sets due to incomplete or improper module programming procedures. |
| ABS U2024:51 | Control Module Cal-Config Data: Not Programmed | This DTC is only present when a new ABS module is installed, the ABS module is flashed or the ABS module is reconfigured. |
| ABS U2024:57 | Control Module Cal-Config Data: Invalid/Incompatible Software Component | Sets due to incomplete or improper module programming procedures. |
Possible Sources
- Incomplete programming procedure
- Improper programming procedure
- EBB unit (HCU and ABS module assembly)
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
