2023 Ford Escape ST-Line SelectFACTORY OEM SERVICE PROCEDURE

Pinpoint Test R: Abs Module Communication Concern With The CCM (Cruise Control Module)

WARNING: This page is about a different car, the 2022 Ford Police Interceptor Utility and 2022 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Refer to VEHICLE DYNAMIC SYSTEMS for schematic and connector information.

Normal Operation and Fault Conditions 

With the ignition ON, the CCM sends messages to the IPMA over a private CAN. The IPMA then sends these messages to the ABS module, in the EBB unit, over the HS-CAN 2. If the ABS module does not receive these messages within a certain time frame, the ABS module sets a DTC. For information on the messages sent to the ABS module by the CCM, REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description  .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Condition
ABS U2107:00 Collision Mitigation By Braking: No Sub Type Information This DTC sets when the collision deceleration message from the CCM is sent too often or the duration of the message is too long. This is mostly likely caused by a network communication concern or an internal failure of the CCM.
ABS U2108:68 Adaptive Cruise Control: Event Information Sets when the ABS module detects the vehicle deceleration is implausibly high when compared to the vehicle deceleration requested by the CCM. This is most likely caused by an abrupt stop of the vehicle due to a collision, an extreme driving situation, a mechanical or electrical failure of the cruise control system or an internal failure of the ABS module.

Possible Sources 

  • Wiring, terminals or connectors
  • Network communication concern
  • Battery/charging system concerns
  • CCM
  • IPMA
  • EBB unit (HCU and ABS module assembly.)

Pinpoint Tests R: ABS Module Communication Concern With CCM

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.