2023 Ford Escape ST-Line SelectFACTORY OEM SERVICE PROCEDURE

Pinpoint Test BZ: Abs (Anti-Lock Brake System) Module Communication Concern With The SODL (Side Obstacle Detection Control Module LH) Or SODR (Side Obstacle Detection Control Module RH)

WARNING: This page is about a different car, the 2022 Ford Police Interceptor Utility and 2022 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

REFER to: MODULE COMMUNICATIONS NETWORK for schematic and connector information.

Normal Operation and Fault Conditions 

With the ignition ON, the SODL and SODR send messages to the ABS module through the GWM over the CAN. If the ABS module does not receive these messages within a certain time frame, the ABS module sets one or more Diagnostic Trouble Codes (DTCs). This can be due to a SODL or SODR failure, a circuit failure on the CAN or an excessive load on the network. For information on the messages sent to the ABS module by the SODL and SODR, REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description  .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Condition
ABS U0232:87 Lost Communication With Side Obstacle Detection Control Module "A": Missing Message Sets when the ABS module does not receive messages from the SODL in the allowed time. This can be due to a SODL failure, a circuit failure on the network or an excessive load on the network.
ABS U0233:87 Lost Communication With Side Obstacle Detection Control Module "B": Missing Message Sets when the ABS module does not receive messages from the SODR in the allowed time. This can be due to a SODR failure, a circuit failure on the network or an excessive load on the network.

Possible Sources 

  • Network communication concern
  • SODL
  • SODR
  • GWM

Pinpoint Tests BZ: Lost Communication With Side Obstacle Detection Control Module

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.