2023 Ford Escape ST-Line SelectFACTORY OEM SERVICE PROCEDURE

Pinpoint Test BR: Abs (Anti-Lock Brake System) Module Communication Concern With The VDM (Vehicle Dynamics Control Module)

WARNING: This page is about a different car, the 2022 Ford Police Interceptor Utility and 2022 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

REFER to: MODULE COMMUNICATIONS NETWORK for schematic and connector information.

Normal Operation and Fault Conditions 

With the ignition ON, the VDM sends messages to the ABS module the over the CAN. If the ABS module does not receive these messages within a certain time frame, the module sets one or more Diagnostic Trouble Codes (DTCs). This can be due to an VDM failure, a circuit failure on the network or an excessive load on the network.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Condition
ABS U0122:00 Lost Communication With Vehicle Dynamics Control Module: No Sub Type Information Sets when the ABS module does not receive messages from the VDM within a specified period of time.

Possible Sources 

  • Network communication concern
  • VDM

Pinpoint Tests BR: ABS Module Communication Concern With VDM

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.