Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test BQ: Abs (Anti-Lock Brake System) Module Communication Concern With The IPMA (Image Processing Module A)
Refer to: VEHICLE DYNAMIC SYSTEMS for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description .
The IPMA is part of the Advanced Driver Assistance System (ADAS).
With the ignition ON, the IPMA sends messages to the ABS module the over the HS-CAN2. If the ABS module does not receive these messages within a certain time frame, the module sets Diagnostic Trouble Codes (DTCs). This can be due to an IPMA failure, a circuit failure on the network or an excessive load on the network.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS U023A:87 | Lost Communication With Image Processing Module A: Missing Message | sets in the ABS module when the adaptive cruise control data message from the IPMA is missing for more than the allowed time. |
| ABS U053B:82 | Invalid Data Received From Image Processing Module A: Alive/Sequence Counter Incorrect/Not Updated | sets in the ABS module when the counter signal value in the adaptive cruise control data message from the IPMA does not increase. |
| ABS U053B:83 | Invalid Data Received From Image Processing Module A: Value Of Signal Protection Calculation Incorrect | sets in the ABS module when an invalid checksum value is received in the adaptive cruise control data message from the IPMA. |
| ABS U053B:86 | Invalid Data Received From Image Processing Module A: Signal Invalid | sets in the ABS module when the brake precharge request is received from the IPMA with an invalid or incorrect signal value. |
Possible Sources
- Network communication concern
- IPMA
Pinpoint Tests BQ: ABS Module Communication Concern With The IPMA
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
