2023 Ford Escape ST-Line SelectFACTORY OEM SERVICE PROCEDURE

Pinpoint Test Av: Abs (Anti-Lock Brake System) Module Communication Concern With GSM (Gear Shift Module)

WARNING: This page is about a different car, the 2022 Ford Police Interceptor Utility and 2022 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Refer to: MODULE COMMUNICATIONS NETWORK for schematic and connector information.

Normal Operation and Fault Conditions 

With the ignition ON, the GSM sends messages to the ABS module over the HS-CAN2. If the ABS module does not receive these messages within the specified time frame, the ABS module sets Diagnostic Trouble Codes (DTCs). This can be due to a GSM failure, a circuit failure on the CAN or an excessive load on the network. For information on the messages sent to the ABS module by the GSM, REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description  .

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Condition
ABS U0103:00 Lost Communication With Gear Shift Control Module A: No Sub Type Information Sets if the GSM messages are missing.
ABS U0404:86 Invalid Data Received from Gear Shift Control Module A: Signal Invalid Sets if the GSM state message or the GSM button quality state is invalid or faulty.

Possible Sources 

  • Network communication concern
  • GSM

Pinpoint Tests AV: ABS Module Communication Concern With The GSM

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.