Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Ford GTFACTORY OEM SERVICE PROCEDURE
Exploded View Of Lower Engine Block
Lower Engine Block (View 1)
| Item | Part Number | Description |
|---|---|---|
| 1 | 6375 | Starter ring gear |
| 2 | 12A227 | Crankshaft sensor ring |
| 3 | 6K301 | Crankshaft rear seal retainer plate |
| 4 | 9D290 | Oil pressure sensor |
| 5 | -- | Oil filter adapter block off plate |
| 6 | -- | Oil filter adapter block off plate gasket |
| 7 | -- | Oil pump belt tensioner |
| 8 | 6622 | Oil feed manifold |
| 9 | -- | Tube and filter O-ring seal |
| 10 | 6622 | Tube and filter assembly |
| 11 | -- | Tube and filter O-ring seal |
| 12 | 6675 | Oil pan |
| 13 | 6L621 | Oil pump seal |
| 14 | 6L621 | Oil pump O-ring seal |
| 15 | 6600 | Oil pump assembly |
| 16 | 6714 | Engine oil filter |
| 17 | 6840 | Engine oil cooler O-ring seal |
| 18 | 6840 | Engine oil cooler O-ring seal |
| 19 | 6A642 | Engine oil cooler |
Lower Engine Block (View 2)
| Item | Part Number | Description |
|---|---|---|
| 1 | 6110 | Piston and connecting rod assembly (6 required) |
| 2 | 6211 | Connecting rod upper bearing (6 required) |
| 3 | 6211 | Connecting rod lower bearing (6 required) |
| 4 | 6010 | Cylinder block |
| 5 | 6K868 | Piston oil cool valve (3 required) |
| 6 | 6333 | Cylinder block crankshaft main bearing (4 required) |
| 7 | 6303 | Crankshaft |
| 8 | 6A341 | Crankshaft upper thrust inner washer |
| 9 | 6A341 | Crankshaft upper thrust outer washer |
| 10 | 6K302 | Crankshaft lower thrust washer |
| 11 | 6A338 | Lower crankshaft main bearings (4 required) |
| 12 | 6325 | Lower crankshaft main bearing caps (4 required) |
| 13 | 6C364 | Main bearing cap support brace |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.