Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Pinpoint Test CE: Abs Module Communication Concern With HVAC Module
Normal Operation and Fault Conditions
With the ignition ON, the HVAC control module sends messages to the GWM over the MS-CAN, The GWM relays these messages to the ABS module over the FD-CAN. If the ABS module does not receive these messages within the allotted time frame or if the messages contain invalid data, the module sets a DTC. This can be due to a HVAC control module failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the HVAC control module, REFER to: Anti-Lock Brake System (ABS) and Stability Control - System Operation and Component Description .
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS U0164:00 | Lost Communication With HVAC Control Module: No Sub Type Information | This DTC sets when the ABS module does not receive any messages from the HVAC module within the allowed time. |
| ABS U0424:86 | Invalid Data Received From HVAC Control Module: Signal Invalid | This DTC sets when the ABS module receives messages from the HVAC module, but the messages contain invalid data. |
Possible Sources
- Network communication concern
- GWM
- HVAC control module
Pinpoint Tests CE: ABS Module Communication Concern With HVAC
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
