Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2022 Ford EcoSport TitaniumFACTORY OEM SERVICE PROCEDURE
Powertrain Control Module (PCM)
| DTC | Description | Action |
|---|---|---|
| P0071 | Ambient Air Temperature Sensor Circuit "A" Range/Performance | GO to Pinpoint Test AM |
| P0072 | Ambient Air Temperature Sensor Circuit "A" Low | GO to Pinpoint Test AM |
| P0073 | Ambient Air Temperature Sensor Circuit "A" High | GO to Pinpoint Test AM |
| P0074 | Ambient Air Temperature Sensor Circuit "A" Intermittent/Erratic | GO to Pinpoint Test AM |
| P0461 | Fuel Level Sensor "A" Circuit Range/Performance | GO to Pinpoint Test C |
| P0462 | Fuel Level Sensor "A" Circuit Low | GO to Pinpoint Test C |
| P0463 | Fuel Level Sensor "A" Circuit High | GO to Pinpoint Test C |
| P0521 | Engine Oil Pressure Sensor/Switch "A" Circuit Range/Performance | GO to Pinpoint Test X |
| P0522 | Engine Oil Pressure Sensor/Switch "A" Circuit Low | GO to Pinpoint Test X |
| P0523 | Engine Oil Pressure Sensor/Switch "A" Circuit High | GO to Pinpoint Test X |
| P0524 | Engine Oil Pressure Too Low | GO to Pinpoint Test X |
| P1933 | Fuel Level Signal | GO to Pinpoint Test C |
| P25B0 | Fuel Level Sensor "A" Stuck | GO to Pinpoint Test C |
| P25B2 | Fuel Level Sensor "A" or "B" Stuck | GO to Pinpoint Test C |
| All other DTCs | - | Refer to Powertrain Control Module (PCM) Input And Output Controls - 2.0L Duratec-HE (129kW/175PS) . . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.