The chart describes specific module configuration information:

Module Name	Module Address	Programmable Module Installation (PMI) Available	Reprogram/Flash Capable	Requires Adaptive Learning or Calibration	Available Progammable Parameters
APIM	7D0	Yes	Yes	No	None
ABS module	760	Yes	Yes	IVD initialization	None
ACM	727	Yes	Yes	No	None
BCM	726	Yes	Yes	No	None
BECMB	723	Yes	No	No	None
CCM (Private CAN)	764	Yes	No	Radar horizontal and vertical alignment calibration	None
DDM	740	Yes	Yes	Windows initialization	None
GFM (remote CD module)	7A1	No	No	No	None
GFM2 (upfitter switch)	7D2	No	No	No	None
GWM	716	Yes	Yes	No	None
HVAC module	733	Yes	Yes	No	None
IPC	720	Yes	Yes	No	None
IPMA module	706	Yes	No	Camera alignment	None
OCSM	765	No	No	OCSM rezero	None
PAM	736	Yes	Yes	No	None
PCM	7E0	Yes	Yes	No	None
PDM	741	Yes	Yes	Windows initialization	None
PSCM	730	Yes	Yes	No	None
RTM	751	Yes	Yes	No	None
RCM	737	Yes	Yes	No	None
SODL	7C4	Yes	Yes	No	None
SODR	7C6	Yes	Yes	No	None
SCCM	724	Yes	Yes	No	None
TCU	754	Yes	No	No	None
TRM	791	Yes	Yes	No	None
WACM	725	Yes	No	No	None

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Module Configuration and Parameter Chart