Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Ford GTFACTORY OEM SERVICE PROCEDURE
Gear Shift Module (GSM): Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the floor console. Refer to: Floor Console .
- Remove the screws and the cupholder.
- Remove the GSM
- Disconnect the electrical connector.
- Remove the bolts and the GSM.
Torque: 89 lb.in (10 Nm)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.