2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Fuel Mass Observer

The fuel mass observer is an algorithm used to detect deviations in performance of all fuel injectors from nominal. The oxygen percentage as measured by the nitrogen oxides bank 1, sensor 2 (NOx12) is compared to a modeled oxygen percentage based upon the current fuel, boost, and EGR settings. The deviation between the measured and modeled oxygen percentage is expressed in terms of the error in fueling required to explain the deviation. This calculated error in fueling is then divided by the current requested fueling level to generate a ratio of percentage error in fueling. This fueling ratio is then filtered over time. If the filtered error in fueling ratio exceeds minimum or maximum limits, then a DTC is set.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.