2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Cold Idle Kicker

The cold idle kicker strategy provides an increase in idle speed during cold engine warm up. The PCM uses the engine coolant temperature (ECT) sensor and transmission position as primary inputs, and in certain conditions the PCM uses the ambient air temperature input to adjust the cold idle RPM up to a maximum of 1, 175 RPM.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.