2021 Ford F-150 RaptorFACTORY OEM SERVICE PROCEDURE

Reductant Pump Control Module

The reductant pump control module receives a duty cycle signal from the PCM and controls the reductant pump operation in relation to this duty cycle. The reductant pump control module controls the reductant pump by energizing the pump motor three phase drive circuits at the required speed in the required direction, as commanded by the PCM. The reductant pump control module sends diagnostic information to the PCM.

G10769101Courtesy of FORD MOTOR CO.

Typical Reductant Pump Control Module 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.